Floor Cable Protector, 3M Cable Cover Outdoor for Wires Floor Cable Tidy, Heavy Duty PVC Floor Cord Hiders with 3 Large Channel, Brown & Yellow

Does what it's supposed to and sturdy recommend.

Fantastic cable protector, i use it when i need to re-charge my car battery as i don't drive it much at the moment.Slight whinge that you need to cut the cable channels yourself.

A lot cheaper than the last one I bought (which was twice the price). I would recommend this for outdoor use, or something that is put down and left, as it is not a soft and flexible as some on the market.Has great amount of capacity for cables, and the central section can easy take the power cable for an EV car (I bought it to run across the pavement outside our house).The cable comes without any cuts. However slicing one in was very easy with a sharp Stanley knife. There is the option for three “cell” and you can open up all three, or just the one.My reason for four stars not five, is that the cable is somewhat curly out of the box. The solution is to get a heat gun and warm the bottom of the cable cover and stretch it out. Then it is flat, but as the plastic is flexible but slightly rigid so it does not curle easily.Given the price, I would easily recommend this cover for garage, outdoor use, or indoor semi permanent settings. If you want a cover that you deploy once a week in a meeting room (and have rolled up for storage the rest of the time), I would suggest getting the more expensive versions that are more flexible.However, given the price - I am very pleased with this product.

Fantastic item and great service recommend highly

Bought this to go over the threshold of my door to cover many wires of Christmas garden decorations. The milkman and myself have both got caught on these and my elderly mum would have probably been next. I cut to put cables in and also reduce the size with my industrial scissors. It was so easy. Looks great and has made my door look so much neater and more importantly reduced trip hazard. Would thoroughly recommend.

The protector was not easy to unroll and flatten from the very tight spiral that it is wound in for transport, the instructions are over optimistic about that process. I suspect that the most inner part would have never straightened, so one should buy a longer run than required and then cut off the bent 30cm or so...There were also brighter "stretch marks" on the cover where it was stressed to roll it up that tight.In the end the product did not suit my need (not because of any of the above!) so I returned it, but if it was suitable for my need I would have happily kept it.

Had two around the edge of a lightly used workshop. Both fell apart and turned into this (see pic) within 6 months of light use. It became more of a hazard than the cable it was protecting!They were cheap, but I expected better than that!

Length and width was ideal and the space for the wires was also generous .I was using it for an EV charger cable at it fitted perfectly .Comes rolled up and you will need to either leave laying unrolled in a warm room to get it to lay flat ,I warmed mine up with a hair dryer which made it softer and then cooled ridged in its flat state .