SUNVIE Fastlock2 Low Voltage Wire Connector Landscape Lighting Connectors 12-18 Gauge Waterproof Low Voltage Connectors Outdoor Landscape Wire Connector for Garden Yard Path Lights, 24 Pack

These connectors were perfect for the installation of our low voltage backyard lighting. I just completed the installation this week and it made everything so much simpler and quicker. Time will tell if they hold up in the outdoor wet conditions next winter, but for now I am a happy camper.I read another review that someone complained that the 12 & 14 gauge wire didn't fit for them, but I used 14 gauge for the closer runs and 12 gauge for the 100 ft run. All 17 of the lights are functioning well. There were no issues inserting the wires into this connector. Not sure what their issue was. I didn't have that problem.One connection came without two of the 4 caps, but I ordered extra. Not a problem.The only challenge I had was in splitting the two halves of the wire. On 3 of the 17 I did manage to slightly expose the wire on one side. I used electrical tape and sealed it up. Lights work. I am happy.I would absolutely recommend these electrical connections.

My electrician was not familiar with these connectors and had his doubts but once he tried them he loved them and said they made a very secure connection and were quick and easy to use

If you are looking for a simple quick connector for hooking up Low Voltage Outdoor Lights, this is your item. They are very easy to use and I never encountered an issue with the connection and the lights all worked.Initially it was a little tricky hooking up the smaller wire from the light fixture as it passes through the securing lock nut. However, if you follow the instructions and insert the wire 1/4" until it bottoms out and then tighten the lock nut it works perfectly. Test the connection by pulling the wire.

These things work well. I was skeptical, but was pleasantly surprised. They are very easy to use. I will use them again.

I bought these for my low voltage wiring system. Unfortunately, I went with 12 gauge wiring and it ended up being too thick, so I had to strip down the wire at the connection point in order for it to work.The system itself is a great design and would have been very simple of I would have had maybe 16 gauge or smaller wire. I'd still be worried about 14 gauge fitting in the slot, or the needle penetrating the rubber exterior.Nonetheless, I highly recommend these connectors and am still very happy that I purchaded them.

Work perfectly. Easy to use. We wired in thirteen lights with 14-gauge main feed line for the 12 volts. I would not suggest these for twelve-gauge as once you separate the wire it will be too thick to push down into the slots which house the pins. Hey, 14-gauge is all you need anyway these days with low power LED 12 V bulbs. A tip to split the main feed wire: use an old, hooked carpet knife. Put the wire on a piece of scrap wood. Press the blade down between the wires, pull up and you create the necessary space to install the connector.

YOU SHOULD NOT BUY THIS! Absolute rubbish. Fully 50% of the connections failed. Most of the caps to tighten the 12V wire pierce fittings cracked and/or stripped. I attempted to reseat several times to no avail. Avoid this like the plague. It does not save time, and certainly not money over the blue silicone stuffed outdoor wire nuts pictured below.

Worked well to connect series of outdoor light. Easy to ise