TotalBoat 5:1 Epoxy Kit (Quart, Slow Hardener)

Great product. Works as intended.

Rather than replacing more than a dozen rotted deck boards. I decided to try to fill the "ravines." I tried many wood putties: n'yet . Bondo? n'yet (Became unworkable too fast for my application). This kit with its slow hardening was perfect. Beyond being simple to use, with the two attached pumps pre-measuring the correct amounts of the resin and hardener. I decided to WILDLY experiment with "additives." First, I added a couple of scoops of Durham's Water Bingo! Mixed easily and perfectly increased the amount of the glop and was easy to spread into the ravines. Dried hard as a rock but it must be abraded hard for painting. Next, I stuffed steel wool into craters, which are deeper than ravines. Then I infused the steel wool with the mixed epoxy. Why? Epoxy bonds with steel and throws off heat to boot. The gaps I filled with steel wool and epoxy are clearly stronger than the original wood fibers because solid steel....Btw: you can perform microsurgery on the "treated" steel wool if you have a competent grinder with attachments. Finally, I mixed grout with sand into the epoxy. Why? Because the sand in this concoction, when used to fill shallower gaps, provided a surface onto which coating would better adhere. Success.Moral of the story: I would have been far, far better off, prying up the deck boards, purchasing new ones, and installing them. Why didn't I do it? I am a retired desk jockey and when I started the project more than a year ago, I did not have the carpentry skills to cut and replace the boards. I have them now. Absolutely no regrets even though the filled-in boards are less than cosmetically perfect.Two warnings: you should absolutely not experiments with epoxy additives. Use only those that the manufacturer prescribes. My outcomes were fine but yours may be disastrous. Second, I could care less about bubbles in the epoxy. Accordingly, my recommendations are expressly limited to the use to which I put the product.

Our travel trailer had bad delamination spots on the side walls from our roof leaking. I watched a bunch of videos of others using total boat to fix the areas. We ended up using clamps and a spray gun to spray the total boat into the bad spots and let them sit overnight. If I did it again I would just use a syringe and inject the total boat into the area as the spray goes everywhere and you cant build it up in the real bad areas.Some spots we used a brush to get a good coat on. It worked very well and when looking at the areas they look just as good as when we bought the trailer. Next I want to try and use it and do a flood coat on a table of some sort.

I used this for a few projects on my vessels it works well. Be mindful of temperature and the mix of catalyst as it will set faster then you think

this is a good epoxy to work with